100 kN | |
1500 rpm | |
1800 rpm | |
55x9 | |
GGG-50, corrosion-resistant | |
steel, case-hardened, ground | |
30,0 kg | |
15,7 kg | |
synthetic fluid grease | |
grease lubrication | |
max. 60°, higher on request | |
max. 53,4 Nm (N) / max. 13,5 Nm (L) | |
N: 4,66 kg cm² / L: 3,38 kg cm² | |
max. 540 Nm | |
Rotating (R) |
- ZIMM | Technical appendix | Design advice (385 KB)
- ZIMM | Technical appendix | Fixing (407 KB)
- ZIMM | Technical appendix | Permissible loads (490 KB)
- ZIMM | Technical appendix | Calculations & Design (675 KB)
- ZIMM | Technical appendix | Tables (216 KB)
- ZIMM | Technical appendix | Operation (476 KB)
- ZIMM | Technical appendix | Maintenance (156 KB)
- ZIMM | Technical appendix | Temperature (108 KB)
- ZIMM | Technical appendix | Application range (83 KB)
- ZIMM | Technical appendix | Resistant against corrosion (83 KB)
Use the optimum lubricant for a long service life! These lubricants have been carefully selected for the requirements of the screw jack.
PDF for Download:
Lubricants for screw jacks
A safety nut is specially applied in such cases where the rupture of the screw may be of danger for people. Safety nut may also be used in other devices to protect against damage of machinery and outages.
Wear
After a maximum of 25% of the thread is worn out, the support nut (R) or the gear (S) needs to be replaced.
Monitoring
It is necessary to perform periodic checks and to record the wear or the thread alignment (according to the time in operation). This enables to plan the replacement soon enough to avoid the outage of the equipment.
Electronic monitoring
Electronic monitoring will signal when the approximate level of 25% wear is reached and this could be immediately displayed at the central location. Wear parts replacement may be organised in a timely manner.
Screw Jack Systems | Z-Series
thread Tr dxP | pitch P | mm | max. permitted wear | thread play* (25% of P) mm |
---|---|---|
16×4, 18×4, 20×4 | 4 | 1,0 |
30×6 | 6 | 1,5 |
40×7 | 7 | 1,75 |
50×8 | 8 | 2,0 |
55×9, 60×9 | 9 | 2,25 |
80×16, 100×16, 120×16 | 16 | 4,0 |
40×20 160×20 | 20 | 5,0 |
Screw Jack Systems | GSZ-Series
thread Tr dxP | pitch P | mm | max. permitted wear | thread play* (25% of P) mm |
---|---|---|
16×4, 18×4, 20×4 | 4 | 1,0 |
30×6 | 6 | 1,5 |
40×7 | 7 | 1,75 |
55×9 | 9 | 2,25 |